Current per 1 LED (mA)

Current of 1 LED in segment (mA) Current of LED in 1 segment.

Dimming system

Durability

Programmable

Dimmable

Lm per meter (Lm)

Dimming method

LED package type

Product optionally produced in colour We are able to produce your selected design, in the following colour / spectral properties.

Light source

Surface colour

Output current (mA)

Max. power Voltage (V)

Electrical protection

PWM Nie, 8bit, 10bit,15bit,16bit

IP degree

Input Voltage (power supply)

Light distribution Type (diffuser)

Outer jacket diameter (mm) Diameter of outer jacket (mm)

LED chip manufacturer

Output Voltage (V)

Viewing angle (°)

Cuttability (mm)

Total el. power (W)

Colour temperature (primary light source) (K) Correlated Colour Temperature CCT (K) of primary light source : is basically a specific numerical measurable definition of light colour of White spectrum according to black body curve (for example 2700K is Warm white Incandescent light, 3000K is wartm white too, but rather of halogene spectrum, but slightly more coldish etc.

Colour temperature (secondary light source) (K)

Colour rendering index CRI

Lx per meter (Lx)

Max. Length when feed from 1 side (m)

Max. Length @ power (Utyp2) (m)

Max. power dissipation (W)

Max. Fibre optic length (m)

Installation profile width

Max. current allowed (ma)

Minimum Voltage (V)

Minimum number of LEDs in shortened semgent MASTER LED strips has advantage to shorten the last segment to different number than standard 6 or 7. After shortening the last segment the SP solder shortening pad should be soldered with tiny amount of solder.

Luminous flux (Lm)

Optical atuenation (dB)

LED axial distance (mm)

No. of LEDs/m (ks)

Temperature increase in working condition (°C) Temperature increase caused by el. device heat up while working in normall operation.

Port diameter (mm)

Constant Current Drivers

PCB width (mm)

Light type

Input voltage (Power supply)

Typical Power Current (Luminaire) (mA)

Typical power current (power supply) (mA)

Typical Power Voltage (power supply) (V)

Fibre optic topology

Active diameter of 1 fibre (mm)

Certificates

Remote Controll

LED strip length on the reel (m)

Features / Additional advantages

Optic typology

Fibre optic transmission type

Effect

External power supply included

Features

Cooling

IK protection

Category of solution

Dimming curve

Case

Surface material

Max. výstupné napätie (V) Max. výstupné napätie (V)

Max. load (t)

Max. allowed input Voltage (V)

Min. output voltage (V)

Fibre optic diameters mix

Mounting depth (mm)

Mounting hole (mm)

Power supply Included

Outer sleeve

Optic

Tilt

Memory

Connection socket

PFC filter PFC filters significantly reduces the electromagnatic interference and prolongs electronic devices

Max. no. of LED BINs used in product

No. of Fibre in total (ks)

No. of output channels

PORT - Fibre minimum (mm)

Suitable for exterior and moist areas

Light transmission (%) Light transmission - the higher the more visible are LED dots and the more light travels out of the light source, however, the less homogenous light effect.

Sensor

Mounting type

Type

IN/OUT terminals

Installation typology

Type of plastics Type of plasts such as PE, PVC, PC, PMMA etc. Each type of plast has individual chemical and mechanical properties.

Fibre optic type

Fibre optic finish

Changeable output parameter

Suitable for surface (m2)

Suitable for installation

Including Light source